| > | |
| > | |
| > | |
| > | |
| > | |
| > |
Proceedings of the 15th International Conference on Manufacturing Systems – ICMaS
Published by Editura Academiei Române, ISSN 1842-3183
Vol. No. 1, 2006
"Politehnica" University of Bucharest, Machine and Manufacturing Systems Department
Bucharest, Romania, 26 – 27 October, 2006
pp. 085-088
ON BORING DEEP HOLES
Constantin MINCIU
Abstract:
This paper presents results of theoretical and experimental research on establishment of cutting capacity of the boring tools for deep holes. After presenting some theoretical considerations regarding the cutting efforts in case of boring deep holes, experimental research results are presented. The experiments were conducted in relation with the cutting efforts, the cutting temperature, the tool life and the chip shapes.
Key words: cutting process, boring, deep holes, cutting capacity, cutting research.
Author:
Prof. dr. ing. Constantin MINCIU, Dean of Engineering and
Management of Technological Systems Faculty, "Politehnica"
University of Bucharest, Romania,
E-mail: minciu@imst.msp.pub.ro
Electronic mail: orgcom@icmas.eu / General Information: http://www.edition2009.icmas.eu/