Proceedings of the 15th International Conference on Manufacturing Systems – ICMaS

Published by Editura Academiei Române, ISSN 1842-3183

Vol. No. 1,  2006

"Politehnica" University of Bucharest, Machine and Manufacturing Systems Department

Bucharest, Romania, 26 – 27 October, 2006

Abstract: The paper analysis several problems appearing at the interpretation of measurement of the profile form. Measurements were carried out on spur gear wheels. Measured tooth profile form emphasized deviations having specific variations from a tooth at another one. As a result, a first problem analyzed in the paper is the extrapolation of the existent measurements on a little number of teeth, to find the maximal profile deviation value. On the other part, the determination of the causes producing these different deviations means is discussed.

Assist. Prof. Dr. Eng. Radu Florin MIRICĂ, Department of

Machine Elements and Tribology, "Politehnica" University of

Bucharest, 313 Splaiul Independenţei, 060042, Bucharest 6,

Romania, E-mail: mirica@meca.omtr.pub.ro

Prof. Dr. Eng. George DOBRE, Department of Machine

Elements and Tribology, "Politehnica" University of Bucharest,

313 Splaiul Independenţei, 060042, Bucharest, 6, Romania,

E-mail: geo@meca.omtr.pub.ro

Dipl. Eng. Marcel DĂSCALIUC, WPC, 250 Basarabia, 030352

Bucharest 3, Romania,

E-mail: marceldascaliuc@yahoo.com