| > | |
| > | |
| > | |
| > | |
| > | |
| > |
Proceedings of the 15th International Conference on Manufacturing Systems – ICMaS
Published by Editura Academiei Române, ISSN 1842-3183
Volume No. 1, 2006
"Politehnica" University of Bucharest, Machine and Manufacturing Systems Department
Bucharest, Romania, 26 – 27 October, 2006
pp. 575-578
STUDY ON DETERMINING THE DRILLING FORCE REGRESSION AT DRILLING COMPOSITES MATERIALS WITH POLYMERIC MATRIX AND FIBER GLASS
Maria OCNĂRESCU, Aurelian VLASE
Abstract: Composite materials are harder to machine than metals, because they are anisotropic, they are not homogenous and their reinforcing fibers are very abrasive. Significant damage to the work piece may be introduced and high wear rates of the tools are experienced while machining. A presentation of the data obtained through experiments and an analysis of the drilling force when machining composites will be made in this article.
Key words: composites, cutting, drilling.
Authors:
Drd. Eng. Maria OCNĂRESCU, "Doamna Stanca" High
school, Romania, E-mail: ocnarescu_maria@yahoo.com
Dr. Eng. Aurelian VLASE, Professor, "Politehnica" University
of Bucharest, Romania.
Electronic mail: orgcom@icmas.eu / General Information: http://www.edition2009.icmas.eu/