| > | |
| > | |
| > | |
| > | |
| > | |
| > |
Proceedings of the 16th International Conference on Manufacturing Systems – ICMaS
Published by Editura Academiei Române, ISSN 1842-3183
Volume No. 2, 2007
“Politehnica” University of Bucharest, Machine and Manufacturing Systems Department
Bucharest, Romania, 22 November, 2007
pp. 133-138
STUDY ON THE FORCES
AT REAMING OF
POLYMERIC COMPOSITE
MATERIALS
Maria OCNĂRESCU, Aurelian VLASE
Abstract: Bolting of composite materials reinforced with fiber glass is a key operation when it comes to assembly. For this, drilling and reaming holes in the materials is necessary. When drilling and reaming into such materials, many problems may appear, very high temperatures at the contact zone between the tool and the material, delaminating of the material, tool wear, etc. The result of research on the variation of the cutting force when reaming are being presented in this paper; during the experiments, three types of composite materials reinforced with fiber glass were used.
Key words: composites, cutting, drilling, machining, forces.
Authors:
PhD, Eng, Maria OcnĂrescu, “Doamna Stanca” High school, Bucharest,
E-mail: ocnarescu_maria@yahoo.com,
PhD, Aurelian VLASE, Univ. Professor, University “Politehnica” of Bucharest,
E-mail: avlase@teh.prod.pub.ro.
Electronic mail: orgcom@icmas.eu / General Information: http://www.edition2009.icmas.eu/