| > | |
| > | |
| > | |
| > | |
| > | |
| > |
Proceedings of the 17th International Conference on Manufacturing Systems – ICMaS
Published by Editura Academiei Române, ISSN 1842-3183
Volume No. 3, 2008
University POLITEHNICA of Bucharest, Machine and Manufacturing Systems Department
Bucharest, Romania, 13-14 November, 2008
pp. 283-286
APPLICATION OF RAPID PROTOTYPING TECHNIQUE IN MANUFACTURING A CONTROL SYSTEM
Mihaiela ILIESCU, Brindus COMĂNESCU, Narcis BARBARII
Abstract: Rapid prototyping represents a new technique of building sample parts, prototypes, in order to improve manufacturing, to test, to evaluate or, just to check on the market. This paper presents a 3D printing rapid prototyping technology applied to an important component – elastic gear sector – of the control system As result of rapid prototyping, several problems that do have negative influence were detected. Thus, the required corrections were made and a proper device could be obtained.
Key words: rapid prototyping, ink-jet printing, Z Printer, elastic gear, control system.
Authors:
PhD., Mihaiela ILIESCU, Assoc. Prof., University "Politehnica" of Bucharest, Manufacturing Department, E-mail: iomi@clicknet.ro
Eng., Brindus COMĂNESCU, Engineer, OPTOELECTRONICA S.A.,
E-mail: brindus@optoel.ro
Eng., Narcis BARBARII, Engineer, RM inkjet printing machine, E-mail: office@3dprint.ro
Electronic mail: orgcom@icmas.eu / General Information: http://www.edition2009.icmas.eu/