| > | |
| > | |
| > | |
| > | |
| > | |
| > |
Proceedings of the 17th International Conference on Manufacturing Systems – ICMaS
Published by Editura Academiei Române, ISSN 1842-3183
Volume No. 3, 2008
University POLITEHNICA of Bucharest, Machine and Manufacturing Systems Department
Bucharest, Romania, 13-14 November, 2008
pp. 219-222
RESEARCHES ABOUT THE CUTTING EDGE TEMPERATURE IN HIGH SPEED TURNING OF QUALITY STEEL
Gheorghe CEAU, Nicolae PREDINCEA, Ioan TĂNASE
Abstract: The determination of the temperature distribution and its maximum along the rake face of the cutting tool is important because, through its control, the conditions of the cutting process as well as the quality of the machined surface will be improved. This paper is the result of the author’s previous investigations on the temperature at the edge of the tool, at the turning of the quality steel, depending on the cutting conditions, with the object of simulating the cutting process in HSC conditions. For the determination of the temperature values there was used an experimental setup with natural thermocouple. The mathematical model obtained through regression method was analyzed for emphasizing the influence of the cutting parameters on the temperature.
Key words: edge temperature, calibration, natural thermocouple, turning.
Authors:
Eng, Gheorghe CEAU, PhD Student, Ministry of Interior and Administration Reform,
E-mail: ceaughe@yahoo.com
PhD. Eng. Nicolae PREDINCEA, Professor, “Politehnica” University of Bucharest, Faculty of Engineering and Management of Technological Systems, Machines and Production Systems Department,
E-mail: nicolaepredincea@yahoo.com
PhD. Eng. Ioan TĂNASE, Professor, “Politehnica” University of Bucharest, Faculty of Engineering and Management of Technological Systems, Machines and Production Systems Department,
E-mail: tanase@imst.msp.pub.ro
Electronic mail: orgcom@icmas.eu / General Information: http://www.edition2009.icmas.eu/