| > | |
| > | |
| > | |
| > | |
| > | |
| > |
Proceedings of the 15th International Conference on Manufacturing Systems – ICMaS
Published by Editura Academiei Române, ISSN 1842-3183
Volume No. 1, 2006
"Politehnica" University of Bucharest, Machine and Manufacturing Systems Department
Bucharest, Romania, 26 – 27 October, 2006
pp. 371-374
METHOD OF SPRINGBACK COMPENSATION BASED ON THE OPTIMIZATION OF DEEP-DRAWING PROCESS
Crina AXINTE
Abstract: The aim of this paper is to present a method which allows optimizing the tool geometry and the process parameters such that the resulted parts satisfy the accuracy demands. The analysis is performed in the case of cylindrical drawn parts and it is based on the Taguchi’s method coupled to the finite element method.
Key words: optimization method, springback compensation, cylindrical drawn parts.
Author:
Crina AXINTE, Assistant professor, University of Bacău,
Faculty of Engineering, E-mail: crina.axinte@gmail.com
Electronic mail: orgcom@icmas.eu / General Information: http://www.edition2009.icmas.eu/