| > | |
| > | |
| > | |
| > | |
| > | |
| > |
Proceedings of the 15th International Conference on Manufacturing Systems – ICMaS
Published by Editura Academiei Române, ISSN 1842-3183
Volume No. 1, 2006
"Politehnica" University of Bucharest, Machine and Manufacturing Systems Department
Bucharest, Romania, 26 – 27 October, 2006
pp. 311-314
ASPECTS REGARDING GENERATION OF NON-INVOLUTE GEAR PROFILES
Constantin MINCIU, Sorin Mihai CROITORU, Silvia ILIE
Abstract: This paper presents the theoretical determination of teeth profiles of the two gears in contact (complementary curves) in case of non-involute gear profiles generation on machine tools by rolling. generalized solution of the gear generation is presented for the three possible cases of gear cutting tools: comb slotting cutter, wheel slotting cutter and flying milling cutter.
Key words: gears, non-involute profiles, rolling, cutting tools.
Authors:
Prof. dr. ing. Constantin MINCIU, Dean of Engineering and
Management of Technological Sustems Faculty, "Politehnica"
University of Bucharest, Romania,
E-mail: minciu@imst.msp.pub.ro
Conf. dr. ing. Sorin Mihai CROITORU, "Politehnica" University
of Bucharest, Romania, Machines and Production Systems
Dept., E-mail: croitoru@imst.msp.pub.ro
Ing. Silvia ILIE, teacher at Industrial High School of Titu,
Romania.
Electronic mail: orgcom@icmas.eu / General Information: http://www.edition2009.icmas.eu/